2. analog
  3. 1193815645

New analog system disappoints, please help

Hi,

I recently decided to get back into analog after a long break. Being on a budget I bought a used system from a local seller. The system consists of a J A Michell Gyro SE with DC motor, SME 309 tonearm and Transfiguration Spirit cart. I also bought a new old stock, factory sealed Plinius Jarrah phono stage. The Gyro, 309 and spirit where all purchased new in 2002 from a L.A. area high-end dealer and set up for the original owner in his home. They have remained there undisturbed and virtually unused since (maybe 15 to 20 hours total use)

After getting it all home I set up the turntable on a carefully leveled rack and tried the bounce test for the suspension. What I got was more like the Jello jiggle than a nice verticle bounce. I followed the instructions I found online for adjusting the suspension (several times) and although not perfect the bounce is much better. I have not touched the tonearm/cart alignment as I know little about this. I left the Jarrah set to factory default high output and adjusted the loading to 100ohms (recomended for the spirit)

After a 24hr burn in for the Jarrah I started to listen to some LP's. The sound is not bad, there is nothing obviously wrong but it sounds slightly recessed, flat and lifeless. I guess I was expecting more even from a relatively modest system like this. It doesn't "blow away" my digital source.

The rest of my system consist of Art Audio VPS DM pre, Art Audio Diavolo amp, Lector CDP-7T-MKIII and Spendor sp100 speakers. Cables are a mix of Nordost Valkyra and Quattro fil.

Any suggestions, incite or setup help would be greatly appreciated.

Emilio
emiliop

Showing 1 response by sonically_challenged

sonically_challenged
7 posts
 
From the hi fi+ review of the Spirit:
"Output is healthy and loading is fine at the popular 100ohm value. Tracking should be set at 2g, but you'll need to set the bias by ear, as even slight adjustments around the 2g mark made obvious differences to the focus and transparency of the sound. Finally the Spirit is the most VTA sensitive cartridge I have come across. Seemingly insignificant changes in arm height can have a huge impact on the sound quality and especially the sense of life. Precise VTA adjustment is a must, and you should take that into account when considering arm matching."
Although adjusting the spring tension on your Gyro for proper "bounce" should not change the relation of the arm/cartridge to the playing surface, I would look at the VTA first, and other alignment issues next. High gain on the Jarrah and your loading should be fine for the Spirit.
More to discover