Need 20 - 25 foot spk cables.



Having to move a pair of Sound Lab M2's to a new position in the home.  Problem is that the equi rack has to stay where it is.  So I will need 20 - 25 foot cables.  Real high end will be above my pay grade.  I had used in the past real honest to goodness, belden coax in 10 foot runs.  Roger Sanders had used this years ago with his speakers and ESL amp.  I have a ESL amp and to be honest for many years the coax sounded pretty good, but I'm sure I could do better for a long run.  Any comments appriciated.
128x128gammastrep

Showing 2 responses by elliottbnewcombjr

IMO,

Always make speaker cables same length even if one speaker is closer.

Make them longer than you need now, give yourself some 'extra' leeway for unanticipated relocation.

After this and that, and reading theory ...., I decided multi-strand, small diameter, each strand insulated, all in insulated jacket makes most sense to me. Sound like Cat 5 cable?

I made my own long speaker wires, easily and inexpensively. Just buy roll of factory made cat 5, cut equal lengths, twist them, make good connectors each end.

Twist. First time I twisted a long run it was hard. Then I figured out, twist a few feet, tape there, twist other direction a few feet, tape there, repeat. Use colored tape, I have 3 sets, various lengths, different color tape. Sometimes I run 2 systems, SS and Tubes, to test, and to let others hear the difference. 

Same music, CD, LP, Reel to Reel tape, i.e. Sgt. Peppers. Everyone picks tubes over SS. Everyone picks LP over CD. Everyone picks Reel to Reel tape over LP.

Note: noise INCREASES as you go from CD to LP, and INCREASES from LP to TAPE, but, when the music starts, preferences go as I described.

It won't cost you much to make a 25-30 ft pair of twisted cat 5. Then, if you try expensive cables (that you can return), you can compare.



.