Isobaric configurations


Hi does anybody know if an Isobaric driver configuration can be used to reduce the volume of a ported subwoofer system? What are the configurations that would not involve exposing the rear of one of the drivers outside the cabinet?
Does the use of isobaric configurations use any more power? Can I get better performance using the 4 ohm inputs of a voice coil rather than the 8 ohm connections?

Many thanks for any assistance

Hmark
hmark
Vance Dickason's Loudspeaker Design Cookbook is a good basic reference for this stuff and will answer most simple questions. Well worth the price if you're going to be getting into building speakers. As Twl stated, they can be mounted back-to-back or front-to-front (these two are better than back-to-front as they cancel the motor system distortions better).
Yes, they can, but most of the ones I've seen use sealed cabinets.
There are several Isobarik configurations that I've seen.
They include:
Face to face - out of phase,
Back to back - out of phase,
Front to back - in phase.

I have also seen a TL tube configuration which uses a front to back driver orientation, either in phase or out of phase, which has a long TL tube extending from the Isobarik chamber between the drivers.

They will use more power because you have to drive 2 woofers.

As far as using 4 ohm or 8 ohm voice coils, that depends upon your amp's capabilities to drive low impedance loads.

Perhaps someone else can shed more light on this subject.