Since I don't ascribe to that religion
Its not a religion- its based on physics.
At 80Hz the waveform is 14 feet long; it takes 2-3 iterations before the ear can know its there and its frequency. By that time the waveform has bounced around the room a bit, so is entirely reverberant as well as any frequencies below that (and likely some above as well).
That is why a mono signal can be used for bass; its the harmonics of the bass note coming from the main speakers that tell you where the instrument is. The only tricky bit is making sure the sub has no output above 80Hz else it can attract attention to itself.
If the room has parallel walls front and rear a standing wave will exist. The reflection from the wall behind you can cancel the incoming wave, causing a very noticeable and measurable loss of bass at that and nearby frequencies. If this occurs no amount of DSP can correct it, since its caused by cancellation; you could put all your amplifier power into that and it will still cancel. DSP is not a solution and neither are bass traps as they are too ineffective and can't be tuned to the correct frequency needed; different in any room.
But a DBA can break up the standing waves quite effectively. At that point the DSP can do its job correctly, and amplifier power is not gobbled up. So the correct answer to
How does room correction treat multiple passive subwoofers?
is 'quite well!'
Its just physics. I am curious- why do you resist this? I mean beyond being mistreated by another member (apparently now banned), who must not be named?