good cable for internal speaker wiring

I rewired my Spendor S 100s with Cardas on bass and mid and Homegrown silver on top and it worked very well. Heavy on bass. medium on mid and thin on top; say 11.14 and 22 gauge. I would not use magnet wire on tweeter but a smaller gauge myself; not saying it won't work. I was going to use Cardas all round but they sent me too little by mistake. ANY good wire will be an improvement on most speakers.

There is a lot on which gauge to use on the forums; I just found that I liked smaller better. I had to use slip on because the crossover was already set up for it and it would have been very difficult to change. I found a snap on connector which makes a better contact that is made by an automobile parts manufacture for car radios; I'll try to find the box and post the part number. I got them from a local parts store but should be on the web. Cost about 5 cents each.

Direct is best but as I said not practical for me. The connectors are made by Au-ve-co [Auto-Vehicle Parts Co.] and are marked 8774 [2962447 in parenthesis]. Unplated GM 56 Series Terminals. They are brass and are much better than standard ones. My tech friend told me about them, he has used them for quite a while.