Do I need a power conditioner?


I’m in the process of dropping a dedicated 20 amp circuit or 2 into the music room.
So if I have a dedicated circuit for the amp, and a dedicated circuit for everything else,
is a conditioner useful?
I have several fairly decent systems going that I tweek and retweek.
Just got around to upgrading cables. Avoided conditioners because, in general, they dampen the presentation.
Was using a PS Audio PPP for low power components. But fell for the Shunyata spiel.
Plugged in a Hydra 4 with a Python Helix and was very happy with how it cleaned up the Zu Druids.
Seems high sensitivity speakers maybe reveal the grunge also.
Moved it to my system with the Martin Logans and the presentation seemed a bit lean and just a bit lifeless, using just copperhead cable to Hydra. (using all Pangea to get from the Hydra to other components.)
Then I put a Black Mamba from Classe amp straight to the wall and Wow! Single most significant tweek ever for me.
So I’m thinking, maybe I don’t need the Denali I ordered if I just use a couple dedicated circuits and some Shunyata power cords everywhere.
Opinions?
Thanks. :)
leotis
Hey Guys,
Thanks for all the interesting advice.
Definitely gonna implement some.
Just got done cutting holes in the wall and drilling through studs and top plates. Fortunately I could do it on the inside of a closet, and just put the outlets on the other side of the wall. What a mess. Gonna run 2 isolated 20 amp lines.One for amp (Classe CA5200 = 200W X 5). One for components.
Had been using PS PPP for just components. Was always a little suspicious about that unit. Final straw is the vibration and the fan. Figure the Denali is a sure fire upgrade. Classe says "no conditioners."
Shunyata says "no problem." Will be easy enough to do the experiment.
Thanks again.

Hey Ivan,
Don’t actually turn off AC or dryer etc unless the noise is an issue when I’m dong some critical listening. I’m aware that you like to keep the draw balanced between the A and B poles on your main power supply. Easier said than done maybe.
Looked over Alan Maher's web site. Pretty interesting stuff. So I borrowed my sister's "Stetezerizer Microsurge Meter" and measured around. Some of my non dedicated circuits measure better than the 1 dedicated circuit I have.
Also, the circuit where I have the Hydras connected measure significantly lower at all the outlets on that same circuit.I also borrowed her mini conditioner. Kinda like a Shunyata Defender I think. Plugged it in and the measurements are about half of the unconditioned measurement. Similar to the Hydra effect. Gonna take a listen and see how it sounds. A Defender is $195. My sisters unit is $39!
Plugged in the $39 conditioner and couldn't hear a difference.
Bummer. Thought maybe I found a cheap shortcut. :/
leotis-

much is dependent upon your location. After that, a dedicated line is nt a bad idea and an excellent start. Finally, most important, Power Cords do make a difference!

Happy Listening!
@leotis holy crap, I read about the ’sterzerizer’ and how ’dirty power’ is bad for your health. Man, and I thought we (audiophules) were paranoid about dirty power! These guys are claiming that dirty power emits harmful electromagnetic fields that inductively couple to our bodies and cause headaches, insomnia, vomiting, hair loss.. you name it.

And we thought it was just bad for sound. Lookout, we’re all going to die!