I run 2 dedicated 20 amp lines across my carpeted basement floor from my panel to my equipment. I use 10 guage waterproof, shielded cable bought at Home Depot. I have seen this cable run outdoors at concerts so electrocution is not an issue.You can not run Romex solid core in this fashion.The waterproof cable also goes around corners and stays where you put it, much like a good power cord. Try an IEC connector at the end of the cord going to your power amp and forget about an after-market cord for awhile.
Dedicated power,long power cords - waste of time?
I am thinking about putting in a couple of dedicated lines but if I do this I will require extra long power cords, say about 20 feet in length, as the dedicated outlets must be installed across the room from where my system resides? There is no way around this.
Currently I have 3 pieces on 1 15 amp line. Bryston amp, Hovland preamp and my digital gear is plugged into a small BPT conditioner also on the same line. Installing 2 lines would allow me to drive the preamp and amp on their own lines and leave the digital alone on its own.
The downside is having to run 2 really long power cords which I would plug directly into the amp and preamp's IEC inlets.
Am I spinning my wheels here? Is this money down a rathole???
All opinions and/or related personal experiences are most welcome.
Currently I have 3 pieces on 1 15 amp line. Bryston amp, Hovland preamp and my digital gear is plugged into a small BPT conditioner also on the same line. Installing 2 lines would allow me to drive the preamp and amp on their own lines and leave the digital alone on its own.
The downside is having to run 2 really long power cords which I would plug directly into the amp and preamp's IEC inlets.
Am I spinning my wheels here? Is this money down a rathole???
All opinions and/or related personal experiences are most welcome.