I'm thinking about getting some GIK floorstanding panels to place at the reflection points along the wall with windows. Also last night I toed in the speakers heavily so they cross before the MLP. Made a big difference. Sound is very centered now and separated from the speakers, still very deep. Soundstage is smaller, but my speakers are about 8' apart so still pretty good. I'm guessing toeing in totally changed first reflection point.
Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
----------------------------------------
Parameters (from Cube Audio):
Power: 40 W
Efficiency: 92 dB
Frequency response: 30Hz - 18kHz ( 6db)*
Dimensions: 30 x 50 x 105 cm
Weight: 40 Kg
* Frequency response may vary and depends on room size and accompanying electronic equipment.
- ...
- 1567 posts total
V2 drivers for my Nenuphars Monitors (coupled with a Sub 12) arrived 10 days ago. Run them 24/7 for a week, then started listening seriously. V2 is a more refined version of the original F10neo drivers: it does not lose anything (the mid-range magic is fully there), sound is thicker across the entire spectrum (more presence / more meat around all bones) which increases the sense of naturalness & flow. I did not have to tweak my system in any way (MU1-Tambaqui-Icon4se-Amp23r or SIT3, LessLoss cabling), the V2s are here to stay! |
No change, still amazing ☺️ |
@vinpic do you have both the V1 and V2 for back and forth comparisons? Granted there's a long lag time, an hour? needed to swap the drivers. Or is your assessment going by audio memory? Thanks |
- 1567 posts total