2. digital
  3. 161950-76845

BlueSound Stinks(!), anyone?

I am looking for your help.  We recently switched from Sonos to BlueSound to get higher streaming rates.  So far we have had consistent problems and issues(!!).  Specifically, about 50% of the time my and my wife's BlueSound app does not recognize the Node 2i's.  When I delete the app, reinstall it and reconnect the Nodes, we again have the same problems at least 50% of the time.  It is simply a joke of a product and I find we are not alone.  I have tried just about everything.

Also, when I go online to get help, I find that I am not alone and there is a tsunami of negative (to the degree of very hostile) comments about BlueSound and for the most part it is the same issue.  I have tried just about everything and I am about to simply trash/sell mine and go back to Sonos.  If I do go back to Sonos, I will also leave a stream of bad comments on every forum I can since going back to Sonos will represent a big financial loss to me simply because Bluesound is an irresponsible/deceptive company at my expense.

Alternatively, I just want it to reliably work.  Do you you have and advice and/or guidance to get Bluesound to reliably work?  Is there a better alternative to to get higher bit rates thank Bluesound?

Thank you in advance for your help.  Dave


butterman

Showing 1 response by mgrif104

mgrif104
328 posts
 
It can be frustrating. 

If at all possible, connect your Node via Ethernet as opposed to WiFi.  My problems went away completely when I did.  You can get a bridge or set up a mesh network and plug into the Ethernet ports on one of your waypoints.  

Frankly, that’s an easier solution than replacing the router (which is sometimes called for when there are WiFi stability issues).  And, you’ll get the benefit of better WiFi coverage in your home, too.

Good luck.
More to discover