best amp for BASS


My system is in a relatively large room 25x40 with 25ft.ceiling..It is a 5.1 system with meridian 861 and 800.German physics speakers.The Main speakers are Loreley large speakers each having four 12in.woofers.These are bi amped with Xover at 200Hz,with 6db slopes.At present the amps are YBA Passion 1000 mono blocks for the highes(fantastic) and bryston 14bsst for bass.The bass is OK but definitly not great.I would like to augment the bass amp.any ideas?
ramy
I'm partial to Steve McCormack's DNA-2 Revision A amplifier.

There's something spectacular about the bass when using XLR connections thru-out with this particular amp. I've used XLR connections with other amps, including my very highly rated McCormack DNA-2 LAE(Limited Anniversary Edition), but I've not witnessed anything close to what the DNA-2 Rev A does with those 2 additional volts from the XLR connections.

Regardless of which amp you select, you most likely would be better served if you use XLR connections. With XLR connections, the dynamics and bass are most always at least a bit better reproducing just a bit more of that live bite.

-IMO
Bass response is HIGHLY dependent the on the room and where the speakers are placed in the room . What you perceive as an amp issue might be resolved by repositioning the speakers or room treatments. Throwing money at the problem by buying better equipment will only take you so far. Since money does seem to be a major concern, you may wish to seek professional advice on room treatments and speaker placement.
If you like YBA, Krell may not be quite what you expect although it does have tight bass (the 600s on Wilson Sophias). FWIW, I had a Krell KSA 100 for a while and it was good but a little bright.

I liked the McIntosh MC1201 monoblocks the best however, slamming massive McIntosh XRT28 speakers like I have never heard before. Everything was shaking except for the amps and speakers (they weigh incredible amounts). I was impressed but it's a conservativly-rated 1200W per channel amp afterall. At any rate, try to audition whatever you can because room and system synergy are critical for any new component to sound good. Arthur
What great advice!Put the money back in your wallet and take a good look around.What you probably need to do is start to "see" the sound with a rat shack meter and a test disc.Or better yet a signal generator.You mentioned the bass was not up to par, is it weak ? Do the subs max out and make a mechanical distress sound ? How are the four twelves wired ? Do they have an 8ohm load (which would lead me to believe they are series -parallel.Not that Krell amps are not the answer some day, always look further to correct the problem.Sounds like a great system and a whomping big room.Amost willing to suggest old JBL scoops from the pro audio world for that big ol' room of yours.I just built some subs using Adire Tumults with some Adcom 555mkII's and they fit the bill.You may need a parameteric eq to remove room modes and really start to hear the bass.Good luck and post your solution.