markruss

Responses from markruss

Bi-Amp Basics - NHT 29s
Well as Rodman touched on above, you would have to have amps on the top and bottom ends with equal gain if you didn't use the X2 as they would be sharing the same volume control, so unless the tube amp and Parasound you want to use just happened t... 
Bi-Amp Basics - NHT 29s
Get a NHT X2 active crossover and a pair of NHT A1 monoblock amps to bi-amp the 2.9's subs. They are much better than the older SA-2/SA-3 amp/crossover combos. This will also give you more control over the bass by allowing you to dial in flat resp... 
Opinions on newest NHT Absolute Zero
May I suggest you look at the NHT Evolution M5 instead of AZs if you have to put them in/on a bookcase/shelf?They have a boundary adjustment feature which drops output below 300 Hz -6 dbs to compensate for the natural boost these frequencies respo... 
Amplifier to pair with NHT 3.3
For $500 or less, a used Adcom GFA-5500 has 200 watts per channel into 8 Ohms, so it would be even more than that into the 3.3's 6 Ohm load, and it is a Mosfet amp, which is supposedly a little warmer sounding than bi-polar designs.