kanchi647
Responses from kanchi647
| Isolated ground for 20 amp @erik_squires I am strongly considering torus power supplies. Do you have any experience with them.What are the pros and cons?ThankNanda | |
| Isolated ground for 20 amp I have the ability to run 240V. I contacted CARY to see if the CAD 211FE can be run on 240V. Any advantage to 240V for the power amps. | |
| Isolated ground for 20 amp @erik_squires can you please recommend a few power conditioners. I am also looking into power distributors. Pros and Cons?Have you heard of Puritan conditioner which does not limit transient peak currents unlike other power conditioners.ThanksNanda | |
| Isolated ground for 20 amp @ditusa recommended 10/3. I am thinking the bare ground is not used, instead the insulated white is used for ground to make it isolated ground. | |
| Isolated ground for 20 amp Romex 10/3 is solid copper, whereas 8/3, 6/3 is stranded copper. I am taking that solid copper is preferable and enough gauge. | |
| Isolated ground for 20 amp There are a total of 4 wires, what do you do with each wire for isolated ground connection? | |
| Isolated ground for 20 amp http://www.lowes.com/pd/Southwire-Romex-SIMpull-250-ft-10-3-Non-Metallic-Wire-By-the-Roll/3129315 Is this a good one? | |
| Isolated ground for 20 amp @erik_squires thanks for sharing the article.Power conditioners can cost as much as 10K and split single 20 amp circuit among all the components, which should be plenty enough even with 500 amp monoblocks. Running isolated 20 amp circuits is cheap... | |
| Isolated ground for 20 amp Also, help me with recommending good outlets. Does power conditioners help even with isolated outlets? | |
| Isolated ground for 20 amp @lowrider57 I have two ground rods one from each panel (must be 30 yrs old and I cannot see them) that are connected by a thin wire to each 200 amp panel. Do you suggest a third rod and tie back to other two rods?@gs5556 Thank you for the explanat... | |
| Hum with Ypsilon MC26L SUT that goes away with touching @lewm all my components are connected to Shunya V-ray which has 8 outlets.Yes, I am already grounding the tonearm to the SUT and the SUT to the phono stage. Is there a way to connect the ground from Phono stage to pre-amp and amps? Just touch the... | |
| Hum with Ypsilon MC26L SUT that goes away with touching Still hear hum with tonearm phonocable to SUT grounding post + connected SUT grounding post to VPS 100 ground. Are you suggesting to connect another wire between ground post from VPS 100 to Cary SLP 05? I do not see a grounding post on SLP 05. | |
| Tonearm mount to the plinth vs arm board vs rotating arm board vs isolated tower I came across Triangleart TT and was impressed by the design and looks.has completely separate armpods..it’s a belt driveWhat do you all think about the Osiris tonearm? Suspended by a magnet. That great concept.. | |
| Best Tonearm and Cartridge for 4K or under for restored Garrard 301 What do you all think about Osiris tonearm which is held by a magnet.. | |
| FR66S vs Ikeda IT-407 vs FR66FX What do you all think about Osiris tonearm which is held by a magnet.. that’s pretty |