2. tech-talk
  3. 187801-4229

standby mode

Hello all,

 

I'm running a BAT VK-600 amplifier and it's going into standby mode and then switching back to on. Yesterday I had it playing music for about 5 hrs before it happened. Today I had it on less than 15 minutes and it did the same thing.

 

Ive checked rear fuses and the 4 green internal circuit board LED lights are still on. I also am using a different tube preamplifier since first noticing this intermittent problem 6 months ago.... 

Any ideas?

Best Regards

velocityofhue
4 responses Add your response
yogiboy's avatar
yogiboy
5,467 posts
 

If your preamp has a DC leak it will cause that problem!!

stereo5's avatar
stereo5
6,254 posts
 

Does the amp have a setting that puts it into standby if there is a lull in the Music?   I had that problem once with an amp and it turned out there was a switch on the back panel to defeat it. 

velocityofhue OP
177 posts
 

I don't believe so stereo5, Thanks for the tip!

The amp does generate a lot of heat

This is most likely a repair job if I can't find a issue with the wall outlet or XLR input cables

 

velocityofhue OP
177 posts
 

Good to know that yogiboy. Thank you 

Log in to respond
More to discover
80x80
B&W (Bowers & Wilkins) Formation Duo w/ Formation Stands
80x80
Antipodes Audio S30
80x80
Ayon Audio S-10 II Signature Network Player DAC Preamp
AWARD WINNING - REMARKABLE!