2. analog
  3. 137140-35975

Questions about VPI Turntables and rotational speed

I've noticed that my VPI Prime Scout is not as good as I'd hoped at rotational consistency.  This has been measured by two different iPhone apps on my X.  Now, I can get it to stay around 33.33 RPM, but it seems to have a fair bit of flutter.  My thinking is that this could be caused by the relatively heavy weight of the iPhone X in a relatively small part of the turntable, whereas vinyl would produce relatively light weight, in across the entire platter.  Does this sound right, or is the weight of the iPhone probably inconsequential?

That said, I know there are devices made by VPI (i.e. the SDS) that will cause a more optimal signal to the motor.  However, I also know that speed may be varied fairly significantly by moving the motor closer, and further from the center of the platter.  So, given this non-fixed ratio, how does the SDS serve to make a better signal for the VPI?

Thanks!
tre9901

Showing 1 response by tirebiter

tirebiter
16 posts
 
Is the app called RPM? If so, it is garbage in terms of precision and accuracy. It’s self calibrating mode simply does not work well and can see where you get readings all over the place. Try manually timing 100 revolutions with a stop watch, you will see what I mean.

I measure wow and flutter on my TNT with Analog Magik and get measurements below 0.08% (w/o SDS). The RPM app gave me much higher readings...in the range of 0.4-0.5%.

Find an app that measures frequency....with your test record, the phone apps seem to be accurate in that regard. From the readings you can calculate how far off speed is.
More to discover