Help With System hum, Please


I have a hum in my system at higher volume between songs at when lower level imformation on a song is being played.It sounds like an amplified sound coming from the speakers.
My phono pre is a Zesto Andros (stock tubes)turntable is a VPI superscoutmaster,cartridge is a dynavector XX2mk11.The cable between the tt and phono stage is an ortofon phono cable and then cardas golden ref going from phono stage to the pre.

I have tried running extra grounds from the TT with no luck.Could the stock tubes be the problem?The tubes are JJ's.Any suggestions would be great as this is driving me crazy.I have eden sound terra stone footers on the TT.

Being new to vinyl, I have another question.Should the stock powercord going from the vpi sds to the outlet and the pc going from the sds to the tt be replaced with after market power cords?I am not sure what to try next to solve this problem.
Thanks in advance
moonguy
Regards, Moonguy: You may have a ground loop hum. This will sometimes occur with a metal bodied cart on a metal tonearm.

There MAY be a small grounding strap on one of the cartridge's ground pins, see:
http://www.ebay.com/itm/PICKERING-XV15-CARTRIDGE-WITH-D750-STYLUS-XV-15-/181072853132?pt=US_Record_Player_Turntable_Parts&hash=item2a28c8788c.

In this photo (no association with the seller), the first I could find, it's visible on the blue (left) ground pin. The strap is designed for removal, should this be necessary to eliminate this particular ground loop. A nonconductive isolator between the cart & headshell, with nylon mounting screws will also eliminate this type of hum.

Good luck &

Peace,
Marakanetz,

I've used tube phonostages for 14 years now and the only time it was noisy was when it needed servicing, so except for one month during that whole time did I have any hum.
Maybe the problem is the noise ratio of your preamp, maybe is a bad solderes cable... There are tooany factors here to check
It is hard to tell from your description if the 'hum' is grounding or something
else. I would try replacing the tubes- I don't know much about JJ tubes but
assuming the unit uses standard 12ax7, 6dj8 or other small tubes, those
are easy enough to get from a reliable source. If it is grounding hum, you
might experiment with the following:
what is the relative placement of your phono stage to the turntable?
sometimes, you can get nasties induced through that. Also, any chance the
phono cable is near an AC cable? Laying out the cables to keep low level
signal cables away from power cables is a good idea.
try some other cables as well if you have them. I assume, using a different
source, like CD or radio, no hum, right?
Also, try a cheater plug on the phono stage, just temporarily, to see if it has
something to do with the way the unit is grounded.
Finally, did this problem just exhibit itself or has it been there since you've
had the unit? (if it just started, it could be a tube. I've also had experiences
where I'll get noise through the system through some extraneous source,
like an appliance elswhere in the house, or somebody doing something on
the 'grid').
Marakanetz- I have owned a couple of very good to excellent tube phono
stages and none of them have been noisy. I did have tube noise through
the phono stage of my old SP 10 mk ii ARC preamp, but that would rank as
a 'vintage' unit these days. Modern phono stages should not be noisy.
I also don't think upgrading the power cords will eliminate the problem you
describe, though they may improve the sound, particularly on the phono
stage. I haven't experimented enough with high end power cords on my
motor controller to say whether that will make a significant enough
improvement to justify the cost over the more modest power cord I am
presently using there.
I find that when this happens, not often, if I just unplug all of the cables and wipe the contacts the hum will disappear for a couple of years. Voodoo? I don't know but it works.
Good luck!

;^)