toddcowles
Responses from toddcowles
| Does anyone care to ask an amplifier designer a technical question? My door is open. Wondering what your thoughts are on the most significant transition/design element that has improved overall sound quality in today's amplifiers. | |
| Pass Labs “House Sound” vs. McIntosh “House Sound” @tzh21y I haven't listened to the MC275's in proper environment. I don't call listening to them under powering a pair of Sonus Faber's at Best Buy an accurate assessment, which that's the only place I've ever really heard them. | |
| DEQX not discoverable... @almarg Though I appreciate the thoughtful response, it's equivalent to me not putting lugnuts back on a tire; which has never happened, but there may come a day! | |
| DEQX not discoverable... KISS...Keep It Simple Stupid...Had the USB plugged into the audio and not the control port. It's up and running. | |
| PASS LABS XO.2 Preamplifier 3 Chassis or Pass Labs XP-10 I’ve owned the XP-20 for about 1.5 years now, picked it up used for $5k. Swapped out from a McIntosh c2500. I’ll second Karl’s sentiment, the XP-20 is dead quiet. Literally, you can hear what “black” sounds like. It’s extremely transparent, an... | |
| Upgrade from Ayre QB9 DAC Have you considered a PS Audio Direct Stream or Direct Stream Junior?I own the Ayre QB9 DSD and a DSJ. I use the Ayre QB9 as my dedicated headphone DAC. I have A/B’ed them, DSJ was more revealing in the midrange and upper frequencies. Little bi... | |
| Planning out a PS-Audio Stack, seeking advice balance of hardware vs dollars avalible For what it’s worth:I’ve ran the BHK pre, it sounded great, the only drawback, for me, was there are no tone controls. Some music was a little too sharp/sensitive on the higher frequencies, the inability to make slight adjustments made it a no go... | |
| Tube Pre-Amp, vs Solid State with Tone Controls/EQ to take edge off the top end? @almarg for the win! I was reading through this post, thinking a DEQX would solve this. I too faced the same issues with “awkward” high end frequencies, too bright, but not consistent. I say “awkward,” because the high end wasn’t consistent on ... | |
| Subwoofer recommendation for Dynaudio Confidence C4 I own a set of C4 signatures and use a REL R-528. It’s quite sufficient. If you do end up using 2 subs, you may face some challenges with getting them phased and integrated properly, key word being “may.” I use a DEQX to get the alignment for t... | |
| Next Gen replacement for McIntosh C2600 pre-amp Others will likely chime in, but that chassis has been out for a few years. I had a C2300, same chassis as C2600, and I bought that new about 4 years ago. The C2600 has updates to support DSD and had new tube circuitry. If I had to guess, the c... | |
| Moving to smaller room... Thank you yogiboy. But, I'm trading in the Dyn's and those are the only two versions of Harbeth's they have. | |
| VooDoo Cables I don't fully subscribe to the "cables make a difference scenario," but have splurged on expensive cables despite that. In system to system comparisons, with cable x vs y, it's very difficult to validate any improvement, other than your ears. In... | |
| DEQX Final Config and impressions... @ozzy contact him [email protected] | |
| DEQX Final Config and impressions... @ozzy I don’t believe he’d have a problem with it being posted, but I sent him a text to verify. | |
| DEQX Final Config and impressions... @ozzy Hi Ozzy, Larry is an independent consultant and is outside of the support provided by DEQX. Used or new, he can help you configure it properly. |