moonglum

Responses from moonglum

Anyone using a Lyra Delos yet?
11-29-10: Paperw8"from where you are getting your data on input capacitance? my whest manual provides no information on input capacitance. an input capacitance of 220pf sounds a bit high even for a moving magnet section."-----------------James Hen... 
Anyone using a Lyra Delos yet?
100pf seems extraordinarily low for the RDT? My ps0.3r has a 220pF input C, while the 0.5m cable is assumed to be around 50pF Giving me a total of 270pF. By way of contrast a Trichord Diablo is way up there at 1.1nF(?) but as Audiofeil says it doe... 
Anyone using a Lyra Delos yet?
Paperw8 :"55dB will send a signal of about 1/3 volt to the preamplifier where 60dB sends a signal of about 0.6 volts to the preamplifier."Hi Paperw8...the Whest manual merely says "0.6mV-0.35mV = 55db setting", "0.4mV-0.25mV = 60db"(personally I w... 
Anyone using a Lyra Delos yet?
Paperw8, I'm also starting to use a Delos into the Whest (although not the dual transformer version) on the 55db setting. I sympathise with the value-for-money argument that this design represents.I must admit that I agonised over the best choice ... 
Graham Phantom Bearing Removal
Tobes...your procedure is so well stated it should be cut & pasted into the Phantom manual. :o) However in my case the T/T is in a corner, accessed from the front and effectively boxed in 3 sides so lifting the bearing from behind the counterw... 
Graham Phantom Bearing Removal
Thanks Has2be. Just looking ahead to when I'll need to remove it again (not dialed in yet but I think there's 0.5cc damping fluid in the bearing well as recommended)I did consider using the arm clip to stabilise it but feared stressing the arm tub...