livin_262002

Responses from livin_262002

Awaiting a 1st impression
@boostedis Aesthetix is an established brand and has been in business since early 2000s. I have Rhea phono in my system. Their customer service is second to none. I had an issue with my unit so I emailed them on a Friday afternoon and I got a call... 
Isolation Advice Needed
Thank you all, placed an order for Townshend isolation corners. Will report back when I have them installed.   Best Regards  
Isolation Advice Needed
@edgyhassle Thank your for confirming my hopes by attesting  their effectiveness.   
Isolation Advice Needed
@slaw  Thank you. I had the same thought. I'll probably go with F (flat) type, the spikes on my rack are removable.   Best Regards  
Isolation Advice Needed
@antigrunge2 Thank you. Seismic sink is no longer offered but I'm leaning towards seismic isolation corners to isolate whole rack, especially one that houses the TT and tube electronics. They are not cheap but I can't seem to find anything else th... 
Isolation Advice Needed
@oldaudiophile wall mount is a no-go, no load bearing wall to not sturdy. I really like the P6, especially with the new Audiomods tonearm. I have a soft corner for vintage Tandberg gear, specifically their magnetic players. Have accumulated a lot ... 
Isolation Advice Needed
Thank you all for all the great suggestions.   Best Regards  
Isolation Advice Needed
The equipment I listed in my original post are only the ones that I thought were VERY sensitive to vibrations. I have the following additional components ...   1) Tandberg TD20A SE (Reel-to-Reel) 2) Tandberg TCD-3014A x 2 (Cassette decks) 3) O... 
Isolation Advice Needed
@whart Active air suspension, as you aptly pointed out, might leave table in an uneven profile for a short time while it tries to adjust. MinusK seems to be a better all-round solution, if needed. @steakster Thank you, did research those too. All... 
Isolation Advice Needed
@whart I'm going crazy trying to find a non-crazy solutions.  
Isolation Advice Needed
@whart Thank you for sharing your experience. My house is brand new so no give in the floor but just that I’m not used to non-concrete floors. I still feel there’s going to some amount of floor vibration, be it be from speakers or people walking. ... 
Isolation Advice Needed
@jerrybj Thank you for seconding BR pads. I’ll give them a try under my amp, phono and turntable.   Best Regards  
Isolation Advice Needed
@antigrunge2  Thank you for the suggestions. I'll look into both. I'd have thought Svelte shelf would go under components and BR pads under speakers :). Thank you for complimenting my speakers and amp I really like the combination. Graaf did make ... 
High Quality Input Switch?
Try to find a Zektor HDS 4.2 A/V switcher. It does passive switching of analog signals using high quality relays just like input selector in amps and preamps. It's a high bandwidth unit that can switch video and digital signal as well.   
Cassette decks. How good can it get?
@richopp Tandberg's were priced lower than TOTL Nakamihci decks IIRC around $1200. They were sold in lower numbers as well. Dragon was one of the best and longest selling Nakamihcis