kichoi
Responses from kichoi
| AR m-1 holographic setup help. As I recall, they were one the few speakers that gave such a wide sound stage even back all the way against the wall. I did also have the two fronts and center on 24" speaker stands and had two more for the rear mounted on a wall mount braket high... | |
| Bryston vs Marsh To add to previous posts, you can be assured that there's always a high demand for used Bryston gear especially the ST series amps if you find it opposite to your liking. I am not so sure about the Marsh equipment.I have had and still has a Brysto... | |
| Revel Salons or Studios? Clueless:Can you share Art's URL? | |
| vmps, art d/io, & boldercables.com ART DI/O even in its stock status is still the Gem of the Audio Gem. I use one with a 2.5A power supply, unmodified in my system with a satisfaction - a rare condition for anyone who's been blessed with the disease... | |
| my Talon Khorus sounds bad Have you tried repositioning your speakers? As previous poster had implied with suggesting the room correction devices, your room has more influences in the way your whole system sounds than changing any part of your amplification chain, IMHO. It ... | |
| this ever happen to your audio alchemy pro 32 ?? One last step you should take before declaring Pro 32 Dead, is to power down all of your digital front end gear (unplug it from the wall). In cases where folks used Audio Alchemy DDS Pro transport and connected via I2S bus cable, Pro 32 received +... | |
| Best tube pre-amp with remote vol. control Although I am going back to Solid State for multichannel setup, I had good services with Sonic Frontiers Line 3 and 1. They are very natural. Since they don't have their own signature sound of their own, you can add your flavors with different tub... | |
| this ever happen to your audio alchemy pro 32 ?? Are you using the I2S input on the DTI Pro 32? Let me know what transport you are using.I have two Pro 32's working in my systems (most of the times...) | |
| what is the best speaker cable? In my relatively short experience with various amps and speakers, I found speaker wires do change the sound the system especially using one of those with lumps near the ends. :-)I found there's no better cable than "no" cable ideally (for both spe... | |
| DTIPro 32 on the Blink Most of the AA stuff was finiky but DTI Pro32 was the worst in my experience.First of all, which input are you using? If you are using the I2S input, remember that even if you have your DTI Pro32 power off, it is still getting +5v from the transpo... | |
| I2s Connectors Try www.mouser.com or www.digikey.comthey list the connector under mini-DIN section.Ki | |
| Two channel or to multi-channel, that is the ??? Try Sony SCD-XA777ES for ultimate two channel Red Book CD and multichannel SACD playback.Who said you can't have it all?Ki | |
| Audio Alchemy Remote Question Ben:Before you can simulate the code or use the original remote wand, you must have a remote chip installed in the DDEv3.0 and a small jumper.You can open the case and see if it has a remote chip installed or a jumper board near the front of the u... | |
| Two Krell FPB 350mc versus one Krell FPB 600c It seems FPB600c vs. FPB650MC would be a better comparison. I've been using the 600C with good results but often wondered how it would sound if I can eliminate the speaker cable variable with the 650MC monoblocks with shortest connection possible.... | |
| B&W N.802 on 7" Sound Anchor speaker stands. The major difference in having the Sound Anchor stands is tilting the speaker up on the front to improve the time alignment performance of the tweeter and the drivers. I do not hear much difference in bass characteristics but do prefer having the ... |