electroid

Responses from electroid

Behringer DEQ2496: Ease of Use
I was wondering if I can use my CDP's dig out into the unit-correct and then dig out to my CDP's dig in. (MF Trivista) I do have to choose the dig in on the MF remote. I just don't know if the dig out from the transport keeps working when I do tha... 
cable dielectric cause of artificial sound
All my cables are now dielectric free......well except the power cables. But they have a lot of cotton between the cable and dielectric. My interconnects ansd speaker wire and my rewire inside my speaker boxes are all enamel coated solid wire. Bes... 
How many pair of speakers do you own?
six here :Quad 988's -bought new - in main system rotationPolk SDA SRS 1.2TL- bought used- in main system rotationMagnepan MG-1 -gift! - storageMinimus 7 wood -bought new -storagePolk SDA-1 bought used -storagePolk Monitor 5- gift - On PC w/NAD amp 
Most Impact on Sound Stage/Imaging?
Crossover and rewire the box with solid enamel coated wire, no teflon coated wire. Also as others said- treat the room. ET 
passive preamp matching
I have a Placette and love it. http://www.placetteaudio.com/passive_line.htmThe owner will answer all your questions and they have a guide for passive users on the home page (placetteaudio.com) Good luck. He has a satisfaction guarantee ET 
Information on the Conrad Johnson Evolution 2000?
I knew you would like them. ET 
Information on the Conrad Johnson Evolution 2000?
No I don't have one but sold a few. I have an earlier CJ MF-2500 and MF-2100. It wasn't difficult to modify them to accept a detachable IEC power cord. You'll need a dremel tool. I think that this is more important than internal upgrades like caps... 
My system is bright? I need help. thanks
Its a device that would work well on your power amp, I would still regenerate sources. FYI the Shunyata Taipan power cord was brash on the high end in my system(on the CDP). Richard Grays were much better and smoother. They are both around $800 re... 
Anyone else tried the GrungeBuster 2.2 CD Mats ?
My CDP swallowed a 2.2 - Herbie quickly refunded my money on the two I bought - even before I could tell him to trade them in for an old larger style one. From new they were easier to install but quickly four sides (in a square pattern) were no lo... 
My system is bright? I need help. thanks
A regenerator takes the incoming AC converts it to DC, cleans it and then convertsit bak to adjustable AC. Adjustable in that you can vary the frequency from 60-120hz (I like 120 hz best on my CDP) and wave type sine,suare, mixed etc. This is avai... 
Beginner/ Starter cables
Mapleshade or Anticables 
My system is bright? I need help. thanks
I have an MF Trivista SACD tubed player. It took a while to get the harshness out. It took a very good power cord, regenerated AC, and the right interconnects. PS Audio noise harvesters really helped clean the AC of junk that the components themse... 
Information on the Conrad Johnson Evolution 2000?
It's nice. You'll like it. Warmer than most amps because its CJ and because the driver stage is tubes (5751)Should sound nice w/Apogees. No limitations it's a 200 WPC amp and doubles at 4 ohms because of the good power supply. As for tricks I say ... 
HELP: No sounds out of my tweeter.
The system should have been off when you connected the cable. Then slowly introduce volume. If the cable is bad you won't be able to get any recourse since the problem may have happened after it was shipped or given to you. Are you sure they were ... 
60 hz ? low level hum through speakers??????
Ground loop from cable or sat- disconnect it and see as previouslt posted