More Tubes = Better Sound

Could one take away from this that with the Ref 75 and klipsch speakers, clipping the amp is very unlikely?

"In theory," fewer tubes mean less concern with mismatched tubes, which means less muddled sound. A lot of purist won't even except two output tubes per channel in a parallel single-ended setup for this reason.

But, in practice, there are quite a few advantages to more tubes to achieve a given output. One advantage is not having to run the tubes as hard. When run well under their rated output, most tubes will last MUCH longer, and this may actually mean lower cost for tube replacement than another amp that uses few tubes but pushes them much harder. Using multiple tubes in parallel lowers the output impedance meaning a lower turn ratio for the output transformer (arguably a positive result), or in the case of OTL amps, a lower output impedance seen by the attached speaker (higher damping factor).

One of my all-time favorite amps is a custom-built OTL amp that uses many tubes to achieve a 35 watt output. The tubes in that amp, which is often left on for months at a time, have not been changed in more than ten years and still test new.

My viewpoint is the implementation is better than the actual topology is more or less. Ex most tubes go from single ended to Push pull or Ultra Linear as the power of the amplifier goes up.

When that happens sound quality goes down. Then when you think about topology of tube amps no one really builds them like SS so most have no bottom end weight. Few companies give them enough current to drive them right and just focus on watts per channel

I am more to the camp of the less is more, but when it involves compromise to get more then be wary

My bad. I should know when to keep my ignorance to myself.