How to use magic eraser to clean stylus?


Always hear people use magic eraser to clean their stylus. Do u just put the stylus on top of the magic eraser like the Zero Dust or is there a other way of using it?
kclaw88
I cut a piece of the Magic Eraser about 1-1/2" long and just place it next to my turntable platter ( actually sits on deck surface ) and with the arm raised ( with lifting device ) I bring the arm over the Magic Eraser and move the arm lift to the lowering position and let it fall slowly onto the the Eraser..It only penetrates Eraser as much as
your Downforce setting allows..I usually raise and lower it a few times and that usually works quite well to remove any fuzz ( or whatever you want to call it )that may have accumulated on the cartridge..I then usally use a small stylus brush and cleaner for final cleaning....
I do the same process as Thorman and works great! That's it nothing else needed, I've looked use a lube scope and it's nice and clean.
Hold a piece of magic eraser underneath the stylus. Press it firmly against the stylus and scrub back and forth vigorously.

Hehe...just wanted to make folks cringe a little.

Disclosure: Do NOT do this. It's a joke (see "Hehe" above).

-Bob :-)
I tried this and my entire stylus disappeared . . . hum, must have been too strong. should I have let it dry out a bit more before using, that way it might not have been so strong.