JL Audio CR-1 Crossover


So, I own 4 JL Audio F-113 subs. Each of these were bought used and all have been updated at JL Audio.

I have been very happy using them in my system. The main speakers are Focal Sopra 2’s. I am using a Iso-Max Jensen transformer(s) model #SP-2SX to connect the subs to my mains and it seems to work pretty well. BTW, the Iso Max unit(s) convert speaker level to balanced (similar to the Rel subs) using Speak-On fittings.

The JL Audio solution to the high/low band pass issue was their CR-1 Electronic crossover. I always wanted to try one of these but at $3000 list I didn’t think it could improve that much over my Iso Max unit(s).

However, I was able to find a used JL Audio CR-1 electronic crossover and I have just now connected it up.

The first thing I noticed was how much very low bass I was missing. Example: Linda Ronstadt “Blue Bayou” the bass now digs into the subterranean.

I guess I need to play with it a while. but I was wonderin’ if anyone else who owns or has owned this unit can share any set ups tips and general opinions of the unit.

ozzy

128x128ozzy

hubbman,

I had my Lumin X1 running direct to my tube amps. I now have the JL CR-1 Crossover in between calibrating my JL F-113 subs.

Basically, I set my subs based on their mic and calibration process, then with the CR-1 I used it to find the best crossover setting. I use the subs internal volume setting more than the CR-1 controls to balance the outputs.

Happy to help further if you need it.

ozzy

Hey Ozzy,

I have the CR-1 up and running, but I’ve run into an issue.

im using scenario 3 where the CR-1 allows me to share both the subs and the front L/R speakers between my AV Processor and my 2 channel Preamp/DAC.

the issue I’m having is related to the fact that my AV Prcessor only has balanced outputs, which is forcing me to use a converter cable turning the balance connection to RCA so I can use the unbalanced inputs on the CR-1.  The balanced XLR connections are used between my 2ch preamp and the CR-1 as the set up guide dictates, while the bypass av processor uses the unbalanced connections.

The issue is; when I hit the bypass button, I get a nasty buzzing in the L/R speakers.  But when I’m using the CR-1 for bass management, there is absolutely no buzzing. 
 

it appears that the CR-1 doesn't like both balanced and unbalanced connections happening at the same time.  If I disconnect the balanced cables from the CR-1 the buzzing stops. 

i suspect it has something to do with the “cheater cables” connected to the AV processor converting the XLR out to RCA unbalanced.

I wonder if you’ve had a similar experience with your set up?

 

thanks!

hubbman,

Now that is strange because I am doing the same thing. I am using Cardas XLR/RCA adapters converting the balanced XLR from my Oppo 205 to a RCA input at the CR-1, while using all the other as balanced.

You may be creating a ground loop, have you tried lifting the ground switch on the back?

So, try just using the XLR output and convert it to RCA at the CR-1 and use them in the RCA managed inputs.

I will double check my connections to make sure what I am saying is correct.

ozzy

hubbman,

I’m sorry I stated it wrong. I am using the mono sub output from my Oppo to a y- adapter then to 2 Cardas RCA/XLR adapters. Plugging those adapters into the CR- 1 Balanced managed inputs.

ozzy