JVC TT 71: buy now for spare for my or TT81?

I must say that I sold a tt-101 and the buyer was shocked to find the platter was lighter on the 101 versus a tt-81 that I also have. We didn't actually weigh the two but it sure did feel like it. Wouldn't the model with the heavier platter be best? I don't want to wrinkle anyones feathers but my GT-2000 is much superior sounding than the Victors! Something to think about. 

Wouldn’t the model with the heavier platter be best?

No

I don’t want to wrinkle anyones feathers but my GT-2000 is much superior sounding than the Victors! Something to think about.

Did you try same tonearm and cartridge on Victor and Yamaha?
Usually the GT 2000 comes with Yamaha tonearm, but what tonearm was on your Victor ?

Also I’m pretty you you can immediately notice the difference between cartridges, but not between different DD drives (it is much more complicated test).

There is a TT801 on Yahoo Buyee with less than an hour left and no bids. Starting at $468.12 USD. Missing the vacuum pump and platter mat is not original.Give me a TT71 or TT81, the TT801 and TT101 are to old at this point without extensive maintenance.

BillWojo

Watch the bigs in the last 30 seconds, not one hour before the auction ending :)) You will be surprised.

Not sure what’s the point to buy an inferior tt-71 or tt-81 if Denon DP-80 is better than all of them.

TT-101 is the ultimate, but for a non working unit prepare to pay $1500 on top for maintenance (not including shipping). Luckily my second TT-101 is working and i’m the second owner.

Elliot, why do you expect your TT81 to fail eventually? I recognize the favorable cost factor with the TT71, but I always prefer buying upscale, rather than down. Also issues with the TT101 are a bit overstated here, and that is partly my fault because I described my problems in detail on this website. In the end, my unit had a single crack across one tracing on one of its PCBs which was very difficult to find both because the malfunction was intermittent and because the crack was covered over with solder. Turns out the Victor PCBs are hygroscopic and their freedom to swell and contract is restricted by fixed mounts bolted to the chassis. This can lead to cracking. But there was nothing wrong with the complex circuit itself. A working TT101 with fresh electrolytic capacitors installed is nothing to be afraid of and is a great turntable. However, I’d stay away from the TT801, especially one with no vacuum motor and no mat. That’s ridiculous.