Why do you need so much power?


I have a basic question.  I have a set of Tannoys with 93dB sensitivity. I’m told that a 25 Wpc amp like the First Watt J2 can power it just fine. (I don’t crank it to 11.). Someone also suggested an Emotiva amp with 500W RMS. 

So my question. Assuming you have a good set of speakers that are efficient (>90) and you don’t crank it till it’s clipping, then do you ever need such power as the Emotiva?  Thanks!
ssmaudio
@boomerbillone

The same reason people drive 250+ horsepower cars - effortless performance. The Emotiva has WAY more power than you will need, so it will never strain. Another BIG factor is that Emotiva’s are reasonably priced.


while there is some truth to what you say, i would only add that there is a very important dimension of quality that matters, not just quantity of watts... if the objective is indeed to achieve great sound
Another point - you might look for actual measurements of your Tannoys if you can find them.  Many/most speakers are not nearly as efficient as the manufacturer's specs indicate.  Sometimes, the difference can be as much as 6db.
By the way 80 watts sounds only about 3X louder than 8 watts.
Should be only 2x louder. Perceived loudness is equal to
k^(1/3.5), where k is ratio of power. For 10x power it is equal to 1.93
10x power is equivalent to 10dB sound level increase equal to 2x loudness increase (3x will be sound pressure change).

@ssmaudio,  the Pass J2 is a great amp, do yourself a favor and pair it with your speakers.   I have never heard or owned an Emotiva amp.

Respectfully, 
Jose
@smrex13
The Tannoys are really quite efficient; the 89, 91, 93, and 96dB models I’ve heard of theirs all seem true to their rating when compared to other brands. You’ll especially notice this if you have a tube preamp without a dead-quiet noise floor. I know that some other brands have more "liberal" with their ratings, or do the 4 ohms / 2 Watts "trick" to add 3dB to the visible spec. Or sacrifice LF extension to goose the efficiency.