Need to replace my Rotel RMB-1095 . suggestions pls

possibly but at this point I am planning to replace both the AV7701 and the Rotel amp.  The AV7701 is an older processor and I want something that supports all the current formats.

That amp, the, "RMB-1095" had a bad "Protection circuit" topology and they, "Rotel" re-designed that entire circuit. Complete with a "New and improved" board a few years after the debut of the amplifier line. 
 I lost a channel in one a few years ago and my "Amp guy" found out about it on a phone call, while ordering parts from "Rotel". So he replaced it also for another $350. Which was the cost of the upgraded protection circuit board + shipping, two years ago. Did they look at this when repairing your amp? Was it mentioned? I think in total it was $680 including a new power supply as well to repair. Which was what goes apparently when the orig. protection circuit fails.

Hee hee, I have a few RMB-1575 amps sitting around if your interested.....

I sent it to Desco. The front left channel board was fried.  Since some of the transistors that needed to be replaced could not be identically sourced, I had them replace the same transistors on both the left and right front channel.  They repaired the power amp board and removed and replaced old glue on both boards.  

I bought the amp new in 2003 so apparently it has served it's life.

Ended up getting a AVM60 that was just listed here and a BNIB MCA 50.