2. cables
  3. 158956-46

Audio envy - dang!

I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming
jayctoy's avatar
jayctoy
3,674 posts
 
After maybe 15 hrs of play and using cardas sweep burn in , my phono Cable it sounds more quiet, one thing I notice is the natural sound of voice and instruments, I use to get crosstalk hum from my Denafrips Dac Ares, now it’s gone , including radio station frequency pick up.This is truly an amazing phono Cable.
last_lemming OP
629 posts
 
@maxima95 

No mine do not look like that. I don’t think there is a pic on the site of mine but I may be mistaken. 
last_lemming OP
629 posts
 
@lalitk 

Why do you say tailor made?  Do you know the gage of each wire, or your best guess?
lalitk's avatar
lalitk
5,055 posts
 
@last_lemming,

Not guessing, I also own SP9’s and the terminations with copper sleeves slides perfectly into the banana barrel of ETI. All you do then is gently tighten the two screws to hold the wire inside the barrel.
bkeske's avatar
bkeske
5,568 posts
 
@jayctoy 

Bkeske it seems like you end up liking AE Cables, they are truly amazing Cables, Iam on my way to order 2 more pc, and one more phono Cable for my SME tt.

You know, my fault in a way, but I purchased my first two sets right at the same time as I improved my phono rig a lot. So, unfortunately all that sonic improvement happened at the same time when installing the new Audio Envy IC's. That said, after a couple weeks with all the new 'stuff' installed, everything did become more transparent overall. And can only imaging the AE IC's were the difference. 

The new set will be going between my phono stage and preamp, so after today, will have a full AE cable 'chain' on my vinyl analog rig through to my amp.

For my digital rig, I chose to check-out Silnote for a digital cable from my CD player to DAC, and Silnote IC's from my DAC to preamp. Very pleased with those as well, but still have AE from my pre to amp in that chain.
More to discover