2. analog
  3. 159598-118120

Hum with Ypsilon MC26L SUT that goes away with touching

I need help solving the hum problem.

Ikeda Kai cartridge -> Ypsilon MC26L SUT -> Ypsilon VPS 100 -> Cary SLP 05 -> Cary CAD 211FE monoblocks -> KEF Blade.
ICs between MC26L and VPS100 Stage 3 concepts RCA
ICs between VPS100 and  Cary SLP 05 Stage 3 concepts XLR
Cary SLP 05 and Cary monoblocks Shunyata RCA
Cary monoblocks to KEF Blade Shunyata speaker cables.

Connected ground from tonearm phonocable to SUT grounding post ->I hear 60 hz hum
Connected ground from tonearm phonocable to SUT grounding post + connected  SUT grounding post to VPS 100 ground ->I hear 60 hz hum (slightly decreased)
Connected ground from tonearm phonocable directly to VPS 100 ground (I read in the forums to try this) ->  I hear 60 hz hum
If I touch the body of SUT (metal) with one hand and touch the metal frame of the rack that sits directly on the floor, the hum disappears in all the above situations.

I used two shorting RCA plugs into input loading of SUT with tonearm cable connected to input-> No Hum 
I used two shorting RCA plugs into input of SUT without tonearm cable-> No Hum
I used two shorting RCA plugs into output loading of SUT -> No Hum

Any help in solving this hum problem is greatly appreciated.

Thanks
Kanchi
kanchi647
kanchi647 OP
70 posts
 
@lewm my home made IC doesn’t have a sheild or ground conductor. Neither does the IC made by Ypsilon. The Stage 3 concepts IC has a ground conductor and I tried multiple configurations which had hum- including connecting only one side, both sides, none, directly connecting the ground of stage 3 to the TT phonocable and VPS100 and bypass SUT.
lewm
12,453 posts
 
Signal ground is essential. Shield is optional. If there is no connection between one unit and the other via ground for the audio signal to travel, then you would only have one single piece of wire. In my mind, that would not work at all, but is that what you Are saying you have?
dover
2,177 posts
 
@kanchi647
Unfortunately like many expensive audio cables, the Stage 3 Concepts phono cables are rich on fancy materials, multiple shields, and fancy sounding jargon. The reality is that there are no electrical specifications on their website for their phono cables.
Given that they claim 4 layer shielding for their phono cables, and use star quad ribbon configuration for signal  it could well be that it is the inherent electrical parameters ( LCR ) of the interconnect that are inducing hum between the transformer and phono.  For example, cables that are capacitive can be prone to hum/rf, particularly in this situation where the signal coming out of the transformer is high voltage, very very low current, meaning the signal is more sensitive to the cable.


kanchi647 OP
70 posts
 
The stage 3 has an extra cable hanging out with spades on either end to connect to the ground post.
my DIY has two wires- center one is conductor and the return is helix..
kanchi647 OP
70 posts
 
@dover the whole concept of stage 3 cables is air-dielectric which is supposed to have the least capacitance (air has the least dielectric)..

More to discover