Primaluna dialogue premium HP tube rolling suggestions to reduce brightness


I have had the dialogue premium hp for about 6 months now, using naim preamp and proac tablette anniversary speakers.  I have been noticing some brightness in the high end, and am wondering is I might be able to switch out the tubes to cool it down a bit.  

I am running the stock el34 and 12au7. As this is the hp with 8 power tubes, I would rather not switch the el34 for financial reasons, so does anyone have recommendation to change the 12au7 tubes.  

I also think the the proacs are contributing to the brightness, but would rather not go speaker shopping again, but have not eliminated that option if you have some ideas
meiatflask
My amps respond well to changing the input tubes.....a lot of guitar amp guys say the same thing....best thing with a prima luna is to call Upscale they are the distributor   
Try any of the US made black plates before you spend lots of money on European ones.  Raytheon, RCA, etc.  
Suggestions to call Upscale is a start.

Since Kevin is the distributor and offers tubes, he can suggest something that also won't break the bank. V11 &12 are the biggest influence other than the power tubes.

Perhaps some of the new production are good deals instead of pricier NOS?


I don’t believe output tube rolling is the answer to the OP’s problem, as the below will still be there and explain.

One must remember speaker and the speaker wire introduce not only a resistive load to the amp but a capacitive one as well. ESL’s even more so capacitive, so all amps theoretically should be unconditionally stable, eg no ringing whatever the load on bench square wave tests.

In Ultra linear mode this amp is a little unstable into 10khz 8ohm pure resistive loading, even without any speaker/wire capacitive loading which would exaggerate this ringing even more which may cause the brightness heard.
http://www.stereophile.com/images/214PLDPfig03.jpg

But in triode mode it seems to be a bit more stable, and should not sound as bright, but still we don’t get to see it with some capacitive loading just 8ohm pure resistive.
http://www.stereophile.com/images/214PLDPfig04.jpg

Even JA "Stereophile) who did the above measurements said this
" PrimaLuna DiaLogue Premium performs at its best with tubes operated in Triode mode."

One can clearly see in ultralinear mode the sharp rising frequency response after 20k this is the rigging seen on the 10khz square waves. "It a bit like an uncontrolled resonance peak of some metal dome tweeters" "brightness???"
http://www.stereophile.com/images/214PLDPfig01.jpg
It seems to me that in Ultralinear mode they’ve gone for too much bandwidth (70khz) at the sacrifice of stability.

But in triode mode all is far better behaved, with no peak after 20k.
http://www.stereophile.com/images/214PLDPfig02.jpg

If I owned this amp I would only use it in triode mode, and if that didn’t have enough power, I’d get another amp that was.


Cheers George