REL Strata III repair issue
| Post removed |
I found this great thread. The Storm and Strata III are supposed to be very similar circuits with the minor difference of additional capacitance. http://www.diyaudio.com/forums/solid-state/198466-anyone-here-own-rel-sorm-iii-sub-2.html |
Hi frogman, I read recently about internal vibrations causing stress fractures of PCB traces in subwoofers. The way that REL attached the power supply board at a 90 degree angle supported on only one side, leaving the heavy assembly unsupported on the other makes this a viable diagnosis. Back in my PCBA days, engineers often used what was called "blue wires" to bypass faulty PCB traces in prototype and early production PCBs, making it possible to complete design verification or to simply consume existing inventory to support customer demand while the PCB manufacturer corrected the issue in future lots. It boils down to soldering small gauge wire from component leg to component leg thus bypassing the faulty trace internal to the PCB. This should be relatively easy on the REL’s power PCB due to the circuitry simplicity of the PCB, the widespread use of pin-though-hole vs SMT components, and the fact that the PCB is single sided with access lands at the ends of most traces. A good electronics technician with adequate soldering skills and a schematic should be able to identify the problem traces/solder joints and apply blue wires where necessary. Dave |
Thanks all for your responses. Update: I now have the Strata in a secondary system using an inexpensive outboard amp/xover (NHT). Getting pretty good (not great) results and the jury is still out on the fate of this Strata. Dave, thanks for your thoughts; I will have a local tech check the defective amp module. Further update: I have bought a pair of REL Storm III subs as I have always wanted to try stereo subs. Well, everything they say about stereo subs is true: smoother, less lumpy bass, improved dimensionality and absolutely huge soundstage among other benefits. So far, I am very pleased with the results, but am trying to diagnose a potential problem with one of the subs. Although there is no sign of distortion or strange sounds of any kind, one of the subs gives noticeably less output (or has lower input sensitivity) than the other. For the same level of output that one sub provides with the volume knob at the 2/3-3/4 mark, the other needs to be almost maxed out. I plan on swapping out the amp modules to make sure that the issue is not with the speaker itself as opposed to the amp module. I contacted REL about this and they tell me that as long as the sub provides undistorted sound that there is nothing that they can do; it either works or it doesn't !?!? Thoughts? |
