how to eliminate another anoying 'hum' from tubed


I never had a ground loop hum before; but I decided to upgrade my gear from a Meridian 861/hd621 switch and G-98 to a VAC Phi Beta tubed preamp, PS audio perfect wave d/t, and a new Marantz 7005 a/v processor. I am using a Parasound A-51 multi channel for center and rears, Velodyne DD-15 sub; Direct tv dish, and Bryston 28 sst's monos for main.
When I connected this gear; everytime I simply touched the hdmi from sat to either my tv; or processor; I had a loud and bad 'hum'; thought maybe it was problem with sat. I had an electrician come out; installed a grounding rod into earth; and also fixed ground. Still had hum; then I realized when I used AEU balanced cables from VAC in cinema mode to Marantz; it created the hum and ground loop. Called VAC; they suggested I use rca ic's, but keep source selection as balanced to 'fool' the ground problem. I did that; and it eliminated 85% of hum, but not all of it. Hum only occurs when I switch the source on VAC from two channel into Cinema mode; otherwise on two channel music; system is completely quiet with no hum. I have three dedicated 20 amp lines.
Does anyone have any thoughts on how to eliminate remaining hum? I did borrow an Integra 80.2 to see if it was problem with Marantz; the Integra had significantly less hum; it may have different internal grounding or switching; also Marantz did send me out a replacement 7005, both units had same hum issues. Is there just bad synergy between VAC and Marantz, or can this be cured. Thanks for your thougths; I have gone thru many different solutions..but not there yet.
Happy Holidays and Thanks...
mribob
Lostbears:
Yes; the ground is isolated to the ground rod; which is located at the opposite side of the house where the main panel is located; over 100 feet away...none of the other sat receiver boxes in house have ground hum; when hooked up to other a/v receivers; only problem is my main rig; and only when the VAC pre amp is switched from 2 channel to cinema mode...which is why I am asking the forum readers for possible solutions...I am stumped...thanks for the thought..
Have you tried a ground isolation transformer on the co-ax for your sat rcvr? Quick and dirty check is to put two of those cheapo 75-300 ohm transformers that came w VCRs (remember VCRs?) back to back and see if it helps. if it does, then get a good one from Jensen or Mondial Magic.
tried a Jensen product; but it states on box not designed for satelite feeds; it only works with cable tv boxes for some reason; I placed one in my rig; reduced hum; but it failed to send sat signal to set; screen had ' searching for satelite' error message...don't know why they are not approved or work for Directv sat boxes...

please try to keep these ideas coming....I am stumped and am appealing to the force of the 'Gon for a cure of the humming blues...
Try lifting the ground on one of your preamps. I had the same issue with my setup also, ARC Ref3 & Meridian G68. You may also have to lift the ground on your sub if it is connected to both preamps.