So much attitude and lack of information here. They are accessible for two reasons; in extreme environments you can adjust the balance to some degree. And yes, they are there for protection as well as equalization in the crossover network. Fuses were determined by Dave to adversely affect the sound and extremely high quality resistors did not. If you don’t want to know there are resistors in your crossover you’d better not look. I have replaced several sets over the years, mainly due to lightning strikes, once for acoustics. I’m getting ready to replace some in a 15 year old pair this week due to a lightning strike. I was a dealer for many years but no longer am. Those who criticize Wilson’s design capability have the right to their opinions. Let me spend some time with one of your designs and I’ll let you know whose opinion I value most...
Wilson Audio MAXX resistors
I am about to replace resistors on my MAXX-1 which is in use for the last 10 years. There is no information in the instruction manual and i have absolutely no idea which resistors are to be used for mid/hi freq.. Does anybody have any information on the effect and procedure for resistor replacement/selection.