Will my speakers be damaged if I use

hello, Will my speakers be damaged if I use higher power than it can handle? My speaker can handle max 125W (manufacture recommend 25W-100W), but I want to buy used amp from a friend which is 200W. So, do you think my speaker will blow up if I use 200W. Thank you very much DT
Although it is unlikely that your proposition will result in damage, why take the risk? Listening to music is supposed to be enjoyable. Worrying about whether your amp will destroy you speaker will make this activity less enjoyable.
No, they will not. Speakers get damaged by running low power amps too hard and clipping them, not by having too much power. You really can't have too much power, it only equals better control and higher threshold before clipping, which is what causes damage.
Alruhl is right...an amp "capable" of 200 watts output does not mean it drives speakers continuously at that level. It means more power available when the dynamics in the music require more power, i.e. crecsendos, heavy bass counts, ect. Unless you like your music very loud, and I mean above 105db—extremely loud for a normal home environment and nowhere close to the decibal level a full 200 watts of power can attain—your speakers will never see more than approxiamately three to five watts continous and ten to 15 watts during dynamic passages. (Remember a speakers sensitivity is in decibals and is measured with a one watt input at one meter away...an 89db sensitive speaker means the sound level one meter from the speaker driven by one watt is 89 decibals). My figures are from memory...any exact figures would be appreciated...I have a chart on wattage input to decibal level output but have not been able to locate.
If ya run a low power amp into any given speaker, when it clips the excessive runaway energy will melt your drivers, especially tweeters. With too much power, you'll surpass the physical limits of the drivers, exceed their excursions, whap the voice coils against their stops, and tear the cones to shreads. Just listen, you'll hear when something's going out of spec. In general I'd rather have too much than too little. The rule of thumb is: buy the most powerful amp you can afford up to the rated limit specified by the speaker maker. But don't sweat it, maybe discovering and marking the upper limit on your level control with a pencil or a lil piece of tape is the answer. Keep the battery in your smoke alarm fresh! :-)