It saddens me to say this but kenjit has been remarkably resistant to learning anything while on this forum. Whatever ideas and opinions he had last year are what he will display this year and no amount of information, help, discussion will add to his understanding of speaker design.
wide baffles and baffle step
Lengthy quotation from Peter Comeau, designer at Wharfedale. Makes a lot of sense to me...
"Th[e] larger ported box, with its subsequent increased baffle size, helps solve a major problem in modern speakers, namely, the baffle step.
I grew up with large speakers with wide baffles, but, as speakers reduced in size over the years I noticed that something was missing from the sound and, when I stuck my head firmly into speaker design, I began to understand the acoustic problems caused by the baffle step.
Put simply, as the baffle size decreases, the point at which the acoustic radiation changes from hemispherical to spherical goes up in frequency. It also becomes sharper and narrower in bandwidth as the sides of the cabinet, and the walls and floor of the room, are further removed from the equation. So, this 6dB step in the power response becomes acoustically more obvious.
I believe that a thin speaker always sounds thinner throughout the midrange when directly compared to a speaker with more generous baffle width. Of course, as designers of modern, slim speakers, we compromise by adjusting for the baffle step in the crossover, but in doing so, we also compromise sensitivity. What starts out as a 90dB at 1W drive-unit often ends up as an 85dB system once we have adjusted for the power loss due to the baffle step."
- ...
- 38 posts total
- 38 posts total