2. amps-preamps
  3. 134869-33771

Who has Luv for the Lyngdorf 2170 and is thinking about the 3400.

Hello All,
I’m coming up on 40 yrs in this hobby,and or obsession of ours,and I started with a pair of Khorns and Macintosh at the age of 12 and Offcourse owned a ton of different gear over the yrs.
I bought a 2170 a little more than 6 months ago and I enjoyed it so much that I quickly realized I don’t really need anything else,solid state,tubes,or even dac’s anymore.I could step off that silly merry go round of amplification and just enjoy music.I was able to utilize the extra money and time and put together a really great sounding network audio system that rivaled the best in analog that I have ever had,I was mainly a analog guy all of these yrs but finally gave it up,I even sold my longtime record collection of 3k records which included many Hot Stampers that I purchased and also several that I found on my own.

So who Luv’s the 2170 and is maybe also thinking about the new 3400.

Happy Listening,
Kenny.

kdude66
Post removed 
Post removed 
robelvick's avatar
robelvick
619 posts
 
Repost - I was curious about subwoofer setup with the 2170.

I have a 2170 arriving tomorrow (going to give it a second chance), and will eventually be pairing it with some Atohm GT1 bookshelf speakers and either a REL or SVS subwoofer.

My question - does the Room Perfect setup set the crossover -high pass/low pass after you do the testing, or do you setup your crossover preference first, and then run Room Perfect?

I will re-read the manual, but would like to hear some suggestions/thoughts in the meantime..
kdude66 OP
1,200 posts
 
You can do it either way,I basically like to setup everything,subs,speaker position optimized and everything else dialed in and run rp last.I do believe I get the least amount of correction for a given room knowledge %.

I hope this helps you,if you have more questions just ask either here or via a pm.

Good luck,
Kenny.
robelvick's avatar
robelvick
619 posts
 
@kdude66 

Thanks!  I did read in the manual that changing the output for the speakers/and or subwoofer will erase any previous RP measurements. 

Guess you have to do that first, then run RP.
More to discover