Which outputs when using Pre as phono front end?


I have an old Threshold FET2 that I want to use at least temporarily as a phono pre amp for my Threshold T3i. Obviously the output from the turntable goes into the phono jacks on the back of the FET2, but which outputs on the FET2 should feed the line in on the T3i line stage - the normal amp outputs or perhaps the tape outputs?

Thanks in advance,

Phil
phil0618

Showing 1 response by jcbtubes

Phil- I don't know the circuit configuration of the FET2, but often the tape-out buffers were merely so-so op-amps. As the tape-out signals were seen as a convenience but not really valued sonically, these op-amps were less than stellar. If this is the case, then the main outputs would likely be preferable, though as Paul mentioned, there may be other sources of signal degradation to consider. The bottom line is whichever sounds best. Be sure to match the level of the two signals between the fixed tape-out level and the main out level when you do the comparison. Enjoy.