2. amps-preamps
  3. 132742-1460

Which integrated amp?

I am looking for an integrated amp for my system and would appreciate any input/ listening impressions for a couple that I have interest in. I have a couple of musts for any choice. At least one set of balanced inputs, pre amp outputs, and 4 ohm drive capability, 150 wpc minimum, solid state preferred but hybrid ok. My room is 11 x 15.5 x 8. I have a couple of different speakers either on hand or that will be arriving soon. They are the Mosaic Acoustics Illumination, and Meadowlark Shearwater Hot Rod. A pair of Green Mountain Audio yet to be released monitors are to be on there way soon (hopefully). The Mosaic and GMA both need subwoofer support, thus the need for pre amp output. I want the integrated to be flexible in case I decide to go with a somewhat larger floor stander in the future. Listen to mostly rock, hard rock, metal, blues, jazz and contemporary jazz. Mostly I listen at modest levels, but want to be able to put the pedal down when I feel like it. I prefer sound slightly on the warm side of neutral and want to avoid etch/ glare. I would like to limit to $3500 in the used market. I have been doing some research and am interested in experiences with the following;

Modwright KWI-200
Hegel H-300/360
Plinius Hautonga
BAT VK 300x SE
Coda CSI 300b
Parasound Halo

I am open to other suggestions. Thanks for your input.

csmgolf

Showing 1 response by pumper24

pumper24
33 posts
 


I have owned and listen to the Modwright kwi200 almost daily for the last 3 years. Here is my thumbnail review.

Positives
  • Powerful- it has plenty to really make my power hungry Dynaudio C1’s sound huge. This amp has 100,000 u/f capacitance, along with a massive power supply.
  • Really good at lower volumes as well. It has been described as a “velvet hammer”. I wouldn’t say tube-like necessarily, but it gives the sense of smoothness that is rare with a high- powered integrated.
  • Well built 60 lb beast
  • Versatile
Negatives
  • Mine has the phono stage, which is just OK (I upgraded to a Manley Steelhead). 
  • XLR inputs are NOT balanced inputs, they are there for convenience if you happen to own gear/ cables that use them.
  • Non-transferable warranty. I know, most aren’t, but my power supply developed a hum audible through the speakers and I had to return it for service. Pretty pricey due to the weight  and shipping both ways. 
More to discover