Where to put my new power cable?


I just recently purchased a Zu Audio Bok power cable. This will be my first after-market power cable, so I'm not sure what to expect. I intend to use it on my front end component section. What I'm curious about is whether I should connect it directly to my Manley Shrimp preamplifier and then go to my Furman power conditioner, or whether I should hook it up to my power conditioner and then to the wall outlet? I know that, ultimately, only experimentation will tell, but I'm curious as to other's experiences...
iramirez

Showing 4 responses by iramirez

Very funny Bojack. However, I'd hope I've yet to garner the kind of animosity that would warrant such a suggestion. Unpleasantly electrifying, I'd imagine.

Cheers,

Ivan
Many thanks folks. I did look through the cable threads previous to posting my query. The reason I posted this one was in the hopes of getting a less ambiguous answer to the question than I found elsewhere. Usually, when I research out a question, I find a sort of consensus that I can use as a preliminary guideline. In this case, opinions seem to be all over the place. As I stated in my original query, I expect trial and error to be the ultimate arbiter. Yes, I intend to let the cable burn in, then I'll move it around for best effect. I think I'll simply connect it to the wall for burn-in, but I think it might eventually be connected to the preamp directly. I'll let you know my impressions once I do.

Cheers,

Ivan
TBG,

Ha, I mean 'consensus' quite loosely. I know what you mean about not finding it. I own a pair of Zu Essence speakers. Just look up the comments on them; people either hate them or love them, there is no middle ground. I only bought mine once I'd actually heard them at home. There was no way to come to some sort of general understanding based on opinions expressed... Like Lou Reed said, "believe nothing that you hear, and only half of what you see..."

Cheers,

Ivan
Well, I received the new power cords yesterday. I ended up getting three of them. I decided to plug one to each Manley 300b amp and one into my Shrimp pre. I got home relatively late last night, so I only listened for a short while and at very low listening levels 64db avg. I put on Van Morrison's Astral Weeks, an album that I've been playing a lot lately. The improvements were readily apparent. Normally, it would take a lot more juice to get the soundstage to be so precisely defined and so stark in appearance, but there it was. The noise floor has clearly dropped lower than I've yet to experience; so, instrumental separation, side to side, and especially front to back, really stands out. Most importantly, however, is the astounding clarity of tone that I perceived. Every instrument sounds more like itself rather than a reproduction. I guess that the most intense change is in micro-dynamics and tonal accuracy. These are just my preliminary perceptions, right out of the box. I am very impressed with the Zu Bok cables. I hardly expected a power cable to have such a positive effect on my components...

Cheers,

Ivan