2. amps-preamps
  3. 1148250090

What's output of 4BST convereted to mono?

What's beter using two 4BST's or 7BST rated at 500 (bench cloder I think to 600) or goiing wiht stereo 14BST if one is after mopst watts per dollars?Also anyone know where one can get to sensitivity swich and this something a consumer should try and find and change?Where is switch and is it it easy to switch to higher imput sensitivity if it is factory or user set at lower number?Any signal degredation i.e more distortion overall if one is using pre-amp anod source which I think fall into standard ouptut voltage ranges (a Mac 712 pre-amp fed by a Proceed player/DAC.
Thanks
Chazz
chazzbo

Showing 1 response by shadorne

shadorne's avatar
Ag insider logo xs@2x
shadorne
7,467 posts
 
I think the sensitivity switch is a simple mod to the 4BST that can you can have done by Bryston - mine has it; two pot screws on the front to adjust sensitivity level.

I would go for two mono 4BST if you really need that much power...they are easier to find second hand.
More to discover