Thecablepro.....thanks for your interest and suggestions..
I am using a VPI Superscoutmaster with rim drive, Classic platter, with BearPaws (large brass cones) which replaced the original feet. The arm is the VPI 3D plastic arm into which I have an Ortofon Winfield installed and loaded at 1000 ohms from the Ayre preamp. I set up the arm using a MINT protracter, and adjusted the azimuth with a Fozgometer...I have an electronic scale to weigh the vtf, and have adjusted it heavier/lighter to get the best performance from the cartridge. The arm is adjusted slightly high at the rear. The arm is wired with the new Discovery wire and is terminated using a balanced (xlr) connection to the preamp (actually, the entire system is fully balanced). Thanks again for the interest.
I am using a VPI Superscoutmaster with rim drive, Classic platter, with BearPaws (large brass cones) which replaced the original feet. The arm is the VPI 3D plastic arm into which I have an Ortofon Winfield installed and loaded at 1000 ohms from the Ayre preamp. I set up the arm using a MINT protracter, and adjusted the azimuth with a Fozgometer...I have an electronic scale to weigh the vtf, and have adjusted it heavier/lighter to get the best performance from the cartridge. The arm is adjusted slightly high at the rear. The arm is wired with the new Discovery wire and is terminated using a balanced (xlr) connection to the preamp (actually, the entire system is fully balanced). Thanks again for the interest.