This is exactly why I don't have a turntable (although the sound is superior in my opinion). I was cleaning the stylus of the last one I owned and literally broke it off with the brush. .......Ok, that was after a few drinks of course but nevertheless, that ended my involvement with turntables.
What have I done to my cart?
While lifting the tonearm (without using the lift) I accidentally dropped the tonearm on to the record. It landed in the label area and was dropped from about an inch above the record. Visually, it seems to be ok but about 30 seconds into the next song, I started getting loud thumping from the left channel, then it would cut in and out (left only). I've read that if the tip had fallen off, the stylus would just skate across the record. The amp is working fine with cd's, so I'm confident it's not that. The cartridge and cables all seem to be tight. The cantilever seems to be working properly as well. Any suggestions?
PS- I know someone will bring it up, so here's my reason for not using the lift. If the arm is allowed to go all the way to the label, the lift is too short to reach the arm. A simple adjustment I know, but it would require removing the table from the cabinet through the rear which is quite a task. It's usually not an issue as I can catch it before it goes too far...
Vpi traveler
denon dl-110 cart
exposure int amp with phono card
PS- I know someone will bring it up, so here's my reason for not using the lift. If the arm is allowed to go all the way to the label, the lift is too short to reach the arm. A simple adjustment I know, but it would require removing the table from the cabinet through the rear which is quite a task. It's usually not an issue as I can catch it before it goes too far...
Vpi traveler
denon dl-110 cart
exposure int amp with phono card
3 responses Add your response