Stanwal- At what frequencies were those compliance readings taken? Everything changes DRAMATICALLY, when read at say, 100Hz as compared to 1k or 10kHz. Read the info available at the last site I recommended, as to compliance ratings. The REALLY important compliance reading, re: tonearm/cartridge resonance, should start at 10Hz.
What defines a high compliance cartridge vs low
This question has two parts and derives from the recent tone arm thread.
What do you think is a highly complant cartridge specification? What would be a low or resistant compliance figure? Where does one draw the line in terms of the specs provided?
Knowing that tone arm mass and compliance are important considerations for optimal performance, then what formula, or ratio do you use for optimal tone arm mass for a given compliance? Or Vice Versa?
What do you think is a highly complant cartridge specification? What would be a low or resistant compliance figure? Where does one draw the line in terms of the specs provided?
Knowing that tone arm mass and compliance are important considerations for optimal performance, then what formula, or ratio do you use for optimal tone arm mass for a given compliance? Or Vice Versa?