wattage difference between SS and Tube


i'm considering to buy a tube integrated amp. however, as this is the first time looking into it, i do not know why so many tube amps have such lower wattage output than SS.i'm looking into Jolida JD 302b and it only outputs 50W per channel. does this mean that i have to crank up the volume control in order to hear the music at all? please help! i need to be educated. thanks.

p.s. i have a pair of thiel cs1.6s if that helps.
davejms
Don't be too serious buying Jolida since you can easily get dissapointed. Research Counterpoint amps or VTL(ST 80 in my mind). There will be better investment for SS amp with the same price as Jolida.
If your serious about getting a Jolida then you should seriously consider buying the 502 instead of the 302. If I recall correctly the 302 uses ( only ) el-34 tubes, while the 502 will use either 6550's or kt88's. I think you will find the kt88's sound best in Jolida. When I did a a/b demo of these two amps I found the 502 was much more musical than the 302.
Tubes generally have less power (about half) than comparably priced ss units, because the parts for a tube amp just cost so much more. Transistors are superior in performance for less money under most circumstances. I'm not a tube fan for the most part, but with Theil's I'd just get a nice SS regardless of where one sits on the tube/ss issue. The 1.6's are more efficient than most of the Theils have been historically and don't have quite as brutal an impedence curve-90db sensitivity and 3ohm minimum-but they still aren't a super tube friendly load. 10 watts will get you to 100db, 50 watts will get you to 105db, 100 watts will get you to 110db with those 1.6's. So a nice quality 50 to 80 watt amp would be the ticket. It all depends technically on how loud you want to listen.
remember for volume differences it takes 10x the power output to double the sound pressure in db. you also need ot consider the current capacity of the amp, usually reflected in the transformer size by an imperical approximation. I have a 150 w/side ss reciever with tiny little transformers it gets lound and nasty. I have a 45 w hand build guitar amp with mondo transformers that can easily play over a large PA (~1200 w/side) its freeking loud and wonderful sounding. long story short...ignore the specs and listen. I use VTL tubes in my system and wouldn't change for anything. Look at their 150 integrated.
Tube 50W "screams" more pleasant than SS 50W. On the lower volume levels they will sound absolutely the same in terms of loudness. The low (10x less than transistor's) output resistance of the tube allowes to draw the maximum current onto the speakers but needs to be matched with the speaker's impedance by means of matching output X-former. Thus even "under-powered" tube amps(i.e. bellow speaker power requirements) can successfully control the driver's coils. On my experience, low-powered SS amps(unless it's Pass Labs Aleph series) can't controll speakers. The beat of drum continues longer, bass isn't tight and deep.

SS designes are soffisticated and require a large amount of negative feedback(upto 30...40dB) to bring the circuit elements(transistors) onto linear operation on the audiable freequencies decreasing dynamic performance that is so necessary for orchestral music. Bringing SS amps to the peak powers will certainly drammatically change the output freequency bandwidth curve and the amplitude will reach non-linear area of output Volt-Amp characteristics(clipping)

Since tubes have linear output Volt-Amp characteristics its designes use minimalistic circuits and very often with no feedback(but for real feedback is needed to increase the freequency bandwidth). The signal is more transperent and open when the circuit path is minimal.
Smaller Thiels can usually get by with 50 watts but benefit from more. Thiels do present a rather linear but low impedance. This would be the major concern IMO. Power requirements can be crudely determined by speaker sensitivity, room size (and construction) and volume sought. IMO it's harder to get an amp with high power to sound good than a lower power amp to sound good, but the benefits are worth it. A very crude (!) rule of thumb as far as power recommendations is to double the manufacturers minimum recommendation. I suggest being as mindfull of Thiels low impedance as much as to the sonic signature of the proposed amplification.
I'm not sure how efficient your Thiels are (I don't think THiels are usually all that efficient), and efficiency makes all the difference. For some speakers, 50watts is two or three times more than they could ever use...for others, it's only 1/10th of what they need. Ask Thiel what the power requirements are for your speakers and ask if they recommend any particular types of amps. As far as wattage and amperage goes, a 50watt tube amp should sound more powerful than a 50watt SS amp (someone else can explain "why", because I'm not electrically inclined). Volume isn't always the issue with wattage, because wattage and volume aren't a one to one ratio. I believe it's a ten to one ratio, so you need to have a 500 watt amp to be able to play twice as loud as a 50 watt amp (everything else being equal).