2. analog
  3. 1236050165

VPI table isolation

I have a VPI Aries table with a Scout motor (long story) setting on top of a Polycrystal rack. As I was making some adjustments tonight, I noticed that when I touched the arm, I could feel the motor vibration. I disengaged the motor from the platter while running and could still feel the vibration.

Any recommendations on how to isolate the motor from the table? I do not want to spend more than $400-$500 as I am not sure how long I will keep this table, but if I could make an improvement, I would do it.

Any ideas would be appreciated
bobkirs

Showing 1 response by islandmandan

Ag insider logo xs@2x
islandmandan
1,260 posts
 
You can buy or make a sand box, and if you cut the portion of the top out where the motor is positioned, and ensure that part is not touching any part of the lid or box, it will do away with any motor noinse being transferred to the table by the platform. Another thing you might check, which happened to me, is that I moved the motor too far, and the power cord was touching the support on the back side, where it was hard to see. Easy fix, that one, but can be hard to spot.

Best of luck,
Dan
More to discover