I've had 2 SDS units where the socket in the back comes off the socket when you unplug the cord. It's a little annoying but the unit actually works. I guess VPI SDS built quality is medicore at best.
VPI SDS Whys and Hows?
Hi Folks, I have a HW-19Jr with Mk-IV Platter (Non SAMA), and VPI SDS.
I had noted upon acquiring this brand new SDS, that there was slight difficulty plugging the Stock wimpy Power Cord from the HW-19 to the SDS, as the Receptacle is recessed, and a tight squeeze getting the connector in. (Why the heck did Harry do this!?)
Over the months, I have thought of going the SAMA route, and of course, preferably the newer SAMA with IEC Connector, so that a better aftermarket Power Cord could be utilized. (perhaps a bargain priced Cord from Signal Cable?)
In this scenario, how would one then plug these Cords with their quite large Male Connectors into the SDS with this so tiny cutout in the Unit?
Advice would be deeply appeciated thanks, Mark
I had noted upon acquiring this brand new SDS, that there was slight difficulty plugging the Stock wimpy Power Cord from the HW-19 to the SDS, as the Receptacle is recessed, and a tight squeeze getting the connector in. (Why the heck did Harry do this!?)
Over the months, I have thought of going the SAMA route, and of course, preferably the newer SAMA with IEC Connector, so that a better aftermarket Power Cord could be utilized. (perhaps a bargain priced Cord from Signal Cable?)
In this scenario, how would one then plug these Cords with their quite large Male Connectors into the SDS with this so tiny cutout in the Unit?
Advice would be deeply appeciated thanks, Mark