I think I understand your question to mean should you "torque" them up.
I hadn't even though of that. I just adjust until the table is level, then try to reduce the height until one of the legs starts getting difficult to tighten. I do this to ensure the motor pully is at the correct height for operation.
Bit of a hassle getting everything even, I am probably not the only VPI owner who wishes the table had three legs.
I hadn't even though of that. I just adjust until the table is level, then try to reduce the height until one of the legs starts getting difficult to tighten. I do this to ensure the motor pully is at the correct height for operation.
Bit of a hassle getting everything even, I am probably not the only VPI owner who wishes the table had three legs.