VPI motor


Hi,
I would like to get a new motor for a vpi 19,I can get one without the pulley.Has anyone replaced if so does the pulley on the old one come off?
THANKS
YOGIBOY
128x128yogiboy
Don't know if you realized this, but the PM 3202-001 is not listed on that page link.
Some of the earlier pulleys just had a dab of superglue that held them in place. Here is a source for the motor:

http://www.beckwithelectronics.com/HURST/pa_pb.htm

It's a PB 3202-001
Yes, I believe the Pulley is a press fit onto the Motor Shaft, and is retained by an Allen Set Screw. Just be careful removing, and replacing, as I believe the material is only Delrin. Mark