2. analog
  3. 1237288365

VPI JMW 10.5i and Dynavector XX2 MK II

It seems that perhaps I should have asked these questions first but better late than never I guess. When I try to figure out things like compliance, tonearm mass, loading, etc. I just end up increasingly confused. So I'm on a quest for at least some other opinions.

a) What do you think about the match between this cartridge and tonearm?

b) I have a Sutherland Hubble which has several possible gain and load settings. What would you suggest for gain and load? For "Recommended Load Resistance" Dynavector says >30 ohms. There are a lot of stops along the way between >30 and 47,000.

c) Damping Fluid - Yes? No? Why?
128x128timztunz
5 responses Add your response
timztunz's avatar
timztunz OP
78 posts
 
All responses are useful and appreciated. Thanks
tom_hankins
928 posts
 
I use the XX2 MKII with a SSM, JMW 9 sig. set at 100ohm. Very small amount of fluid.
I have heard several Dynavector/VPI-JMW combos and they work very well together.
mcdonald43
52 posts
 
I have the XX-2 MkII loaded @ 40 Ohms. It is mounted to VPI Scoumaster/JMW 9 and seems to be a very good match.
sns
3,003 posts
 
This should be a good match, compliance fits tonearm mass. 100ohm loading seems to be a good match for Dynavectors. I use just a touch of damping fluid, start with just a touch, add more until you start hearing the slightest loss of life, dampening. You want just enough to tame any hardness, shrillness, don't go past this point. Some may not have to use any damping fluid, I use just a bit.
utahusker
44 posts
 
I used one with a JMW 9, and it worked fine.
Log in to respond
More to discover
80x80
TriangleART MAESTRO
80x80
ZYX UNIverse Optimum
NEW Product, Two AWARDs already
80x80
Schroder Tonearms CB (Carbon, Ebony 239mm & 282mm)