2. analog
  3. 1220652099

VPI Headshell weight question

So based on a recommendation from Harry (VPI), I purchased the 3g headshell weight for my Scoutmaster/Shelter 501MKII. It didn’t come with any instructions and it’s not obvious how to install it. Does it go between the headshell & cartridge or attach to the top of the headshell?

Also: I assume I re-adjust VTF so that it’s still within recommended range (i.e. Shelter manual) or is the whole point that I need to go over by 3 grams?

Thanks…
madfloyd

Showing 3 responses by madfloyd

madfloyd OP
411 posts
 
That makes sense. I've never setup a turntable myself, although I just bought a digital scale, I have Michael Fremer's DVD, and need to learn sooner or later.

I was hoping that this might be a good time to start if I only had to make 1 or 2 adjustments.

Thanks.
madfloyd OP
411 posts
 
So I got brave enough to install the headshell weight. Even though it was my first time doing any adjustments, I took my time, watched Fremer's DVD and thought I did a good job.

I have VTF at the high end of the cartridge recommendation. I adjusted Azimuth and even lowered the arm height (looked like it was a tad higher at the pivot).

I used the VPI jig (don't have a mint tractor yet).

However, the sound is rather harsh. Highs are thin, metallic sounding and (I think) distorting.

Can someone suggest what aspect of the setup might be off?

Thanks!
madfloyd OP
411 posts
 
That's strange. The weight is very thin - While I had to adjust VTF & VTA, it didn't make that type of difference.
More to discover