Thanks all for your suggestions. They have been very helpful. As of now I have tried the following: grounding the flywheel to the AC outlet ground screw (no change); grounding the tonearm to my phono preamp (c-j premier 15) (no change); install new belts with talc (no change), ensure turntable rack is level (no change); removal of the flywheel (BIG CHANGE FOR THE BETTER). Based on my experience, and at least two of the suggestons submitted, the Aries seems to perform (to my ears) better without the flywheel installed. After first purchasing this table I added the stainless steel clamp (improvement). I then added the SDS. This resulted in a DRAMATIC IMPROVEMENT in the sound. I mean an order of magnitude improvement. I was amazed at how much better this table sounds with the SDS installed. I would recommend the SDS without reservation. I can't say that I have gained anything by adding the flywheel. Thoughts???
VPI Flywheel with Aries Turntable - Help
I recently added the VPI flywheel to my Aries turntable setup (Aries w/ JMW-10, SDS, and Benz-Micro H2O). When using the flywheel, I notice a distinct increase in what sounds like record surface noise (ticks and pops). This occurs at regular intervals. I can only assume it is from the flywheel. I have tried all combinations of grounding the flywheel and tonearm to the AC outlet, my phono preamp grounding post, all to no avail. When I remove the flywheel from the system, things return to normal. Very Strange. Any thoughts or suggestions would be greatly appreciated.